Let us start by introducing the notations that will be useful in the general description of SE and SS emission. The effective broadenings reduce to the decay rates in the SE case but get renormalized by the pumping rate in the SS case:
Thanks to the general relations
and
, we can
obtain from Eq. (3.3) the single-time mean values of interest
for this problem, by solving the equation of motion of the coupled
system:
The expression for
follows from
. The
crossed mean value that reflects the coherent coupling reads:
![]() |
It is of interest to note that Eqs. (3.10)-(3.11)
are reproduced by introducing decay as an imaginary part to the
energies in the Heisenberg picture, i.e., substituting
by
and solving directly in a full
Hamiltonian picture the operator equations of
motion:
with
. This method goes along the
lines of the manifold picture (closely related to the Langevin
equations), represented in
Fig. 3.1. Although essentially incorrect
(as we explained in the previous Chapter), following this method
provides the right average quantities, such as the correlator
and therefore leads also to the correct
expression for the SE spectra. The expressions that we obtain for the
four time-dependent operators (
,
,
,
) solving the Heisenberg (not the Langevin!) equations are all
contained in:
On the other hand, the SS case corresponds to setting the time derivative on the left hand side of Eq. (3.6) to zero, and solving the resulting set of linear equations. The solution
Both photonic and excitonic reduced density matrices are diagonal. They correspond to thermal distributions of particles with the above mean numbers:
Behind their forbidding appearance,
Eqs. (3.15) enjoy a transparent physical
meaning, that they inherit from the semi-classical--and therefore
intuitive--picture of rate equations. When the coupling strength
between the two modes,
, vanishes, the solutions are those of
thermal equilibrium for
and
[Eqs. (2.34)
and (2.52)]. In the general case
where
, the mean numbers can also be written in the same form:
From the point of view of mode
, the coupling with mode
is both
adding particles, contributing to
, and removing
them, contributing to
. The total effective
decay is:
The mean value of the coherence can also be expressed in terms of these quantities:
The quantities defined in Eqs. (3.18) and
Eq. (3.21) are all positive when
(
) and all negative when
(if there
exists a solution for the steady state). The conditions for the
pumping terms
,
to yield a physical state (a steady state),
are therefore those for which the mean values
are positive and finite, implying:
From now on, we shall refer with ``SE'' and ``SS'' to the expressions
that apply specifically to the spontaneous emission and to the steady
state, respectively, leaving free of index those that are of general
validity. In some cases, as for instance in
Eq. (3.4), no index is required if it is
understood that
are defined and equal to zero in the SE
case. For that reason, we shall leave
free of the SE/SS
redundant index.
Elena del Valle 2009-10-11